A short and sweet problem/resolution. If you are looking to enable subnet overlapping on a Fortigate so that you can give multiple interfaces an IP in the same subnet, this is the post for you. NOTE: This feature can only be enabled in the Fortigate’s CLI. To enable the overlapping feature, enter the following commands: config system settings set allow-subnet-overlap [enable/disable] end What is subnet overlapping? Subnet overlapping is disabled by default in fortiOS and for good reason; if you misuse subnet overlapping it can cause massive routing issues for your clients and their traffic....

1st January 2020 marked the official end of python 2.7 development, including feature support and security fixes. Python 2.7 was over 9 years old in development years, making it the longest supported version to date. The code freeze is no in place, with the final release – 2.7.18 – scheduled for an April 2020 release. So yes there will be one more version to come down the tubes but it’s probably best that the new python project you were thinking of starting is written in 3....

They say that the long tail page titles are best for SEO, well this one certainly should be up there with the best of them. In this post, I am going to explain how easy it is to control Kasa a HS100 / HS110 with IFTTT and python webhooks. Using this basic code, you expand into building a very powerful home automation system which fits your needs and take your Kasa home automation to the next level....

I am planning a number of articles which focus on using aircrack-ng and hashcast to recover WPA wireless security passwords. However to get into that you need to have a specific wireless device which supports monitor mode and packet injection. I decided on the Alfa AWUS036AC, but some work was required to get the drivers installed. This guide is based on Kali Linux 2019.4 – but the drivers are certified for earlier versions of Kali and the kernel that 2019....

I have covered changing the default version of python in Debian, however for those looking to Google for a quick fix on Kali, I hope that this reaches you well. This was tested on a completely fresh install of Kali Linux with no other alterations made prior. The basic premise is to configure Kali to use python 3.7 at a higher priority to python 2.7 or any other version installed on the system....